Fitting Advice

On the back of the poster you will find two metal hooks. We recommend that you hang the poster using these metal hooks and 'L' shape hooks. For fitting, there are 2 'L' shape hooks and 2 plastic dowel tubes included in the box.

For wooden walls the plastic dowel tubes are not required. In any case we recommend pre-drilling holes with 2mm (or for hard wood 3mm) drill bit. For every other material it is recommended to use the plastic dowel tube in 5mm hole.

Drill two 30-35mm deep holes at 320mm between each hole. Insert the plastic dowel tubes in the holes, such that the tubes sit roughly ~1mm below the surface of the wall. If needed use a hammer to gently push the plastic tubes in the hole. In the plastic dowels screw in the 'L' shape hooks. The hook should be facing upwards from the wall roughly 10-15mm away. If the wall isn't perfectly perpendicular, you may adjust the fitment of the poster by screwing the hooks in-and-out until you find the perfect fit. Once the poster is hung on the wall, make sure that the hook is under the hanging tab. You may not always be able to fit the two 'L' shape hooks completely level - but do not worry, the hanging tabs are deliberately fitted on the back of the poster at a slight angle, so that you can use the teeth of these hooks to change the level of each side of the poster by +-5mm.

On the back of the poster you will also find 4 rubber spacers. Please do not remove these, as due to the limited space between the wall and the back of the poster, your poster may harmfully overheat over time.